This is an old revision of the document!
Use Electronic Brick sensors
To be able to use Electronic Brick sensors, you have different way to address them.
Using GrovePi shield
You can connect Electronic Brick sensors to the GrovePi. You can read the following page to Install Groove Pi on Raspberry Pi.
Use the following converter cable to be able to connect the Electronic Brick 3 pin connector to the Grove 4 pin.
Just have to play with them now. You can use all sensors (led, rotation, button, tilt, buzzer, …)
Using Phidget InterfaceKit
You can read the following page to Install Phidgets on Raspberry Pi.
You can use the Phidget Interface Kit 8/8/8 to connect the sensors to. You will be able to use the following sensors directly:
- Rotation sensor
- Temperature sensor
- Tilt switch
- Big button
The first two ones have equivalent components in Phidget kit, but the two last ones are interesting to use.